Gas and rangetop · signal
All Igniters Dead After a Boil-Over
When every Wolf burner goes quiet straight after a boil-over, liquid in the ignition is the likely reason, and drying comes before any other check.
| If you see | And | Then | Verdict |
|---|---|---|---|
| No burner clicks at all | A pot boiled over, or liquid ran under a cap, within the last day | Knobs off. Mop up, then leave the whole top to dry; a hair dryer on low helps. Try one knob once all of it is dry. | Safe to wait |
| You turned a knob to HI anyway | Nothing caught within 10 seconds | Turn it back off and wait one full minute before another try, as Wolf's own guidance sets out. | Safe to wait |
| Still silent, and the top looks dry | The breaker has not been reset yet | Switch the cooktop's breaker off for 30 seconds, then on again; the igniters need power to spark. | Safe to wait |
| Every burner clicks again but one | The others came back as the top dried out | That last burner is still wet or fouled at its electrode; carry on with the single-burner signal. Next signal: One burner has no spark | Safe to wait |
| No spark anywhere, even now | The top is fully dry and the breaker reset changed nothing | The spill may have reached ignition parts beneath the top. Keep every knob off and book a visit. | Call today |
If no burner sparks once the top is thoroughly dry and the breaker has been reset, call Redmond Wolf Repair on (425) 905-2822 today.
Cleaning up without making it worse
Wolf’s burner-care advice is built around keeping the ignition dry. Let the burners cool, put mild detergent or degreaser on a soft cloth rather than spraying it at the burner, and keep it off the igniter. Rinse, towel dry and blow out the port holes. Wolf also advises leaving the burner rings in place and keeping rings and caps out of the dishwasher.
How long to leave it
Wolf publishes no drying time, so dryness itself is the test: no liquid left around any cap, in any port or on any electrode before a knob is turned again.