Signals and codes · family
Wolf Gas Cooktop and Rangetop Fault Signs
Gas cooktops and sealed-burner rangetops tell you what is wrong through the clicking, the flame and the griddle light. Match the row to what you see and hear, and follow its verdict.
Wolf Gas Cooktop and Rangetop Fault Signs: signal, meaning and verdict
- Igniter sparks after the flame is lit Moisture, a misplaced cap, or the ignition supply. Safe to wait Call today when: Sparking that will not stop, or starts with every knob off
- One burner has no spark That burner's electrode, its wiring or its switch. Safe to wait Call today when: Still silent once dry, clean and seated
- Clicks come back on a low flame Re-ignition answering a flame that wavers. Safe to wait Call today when: Clicks every few seconds on low
- Flame goes out at the lowest setting Cap seating, blocked simmer ports or a draught. Safe to wait Stop using it when: Flame goes out and stays out, with no clicking
- Every igniter dead after a boil-over Liquid in the ignition circuit; dry it first. Safe to wait Call today when: No spark anywhere, even now
- Griddle stays cold No ignition, or a flame-loss lock-out. Safe to wait Call today when: Still cold, or the flashing comes back
- Charbroiler glows unevenly Preheat, the blank-off plate, or the burner. Safe to wait Call today when: No glow within about 20 seconds, or patches that stay put
How a Wolf gas burner lights
Push the knob in and turn it to HI. The igniter clicks until the burner catches, which Wolf puts at about three to four seconds. Once the flame is lit the electrode keeps watching it, and if something disturbs the flame it sparks again to relight it. That second burst of clicks is normal; clicking that will not stop is not.
The rangetop sections
A rangetop can carry an infrared griddle, a charbroiler or both beside the burners. The griddle holds the temperature you set, and on Wolf’s current gas range its light goes out on reaching it and comes back as it reheats. The charbroiler has one setting, HI, and wants ten minutes to preheat. Both have rows of their own here.
Two checks before any row
After cleaning or a boil-over, let the burner dry; a hair dryer on low speeds it up. Then check that each cap sits flat and centred, and push each knob in and let it go: it should spring back. When a row still says call, ring Redmond Wolf Repair on (425) 905-2822.